Thursday, March 17, 2016

Hexagon Hello (Kendra Sand)





Hexagon Hello
by Kendra Sand


I am in love with how this card turned out!!  So fun and bright!!

I started by taking my main base layer of my card and randomly die cutting the smallest stitched hexagon from the Stitched Hexagons die set three times. I then also used that same die to die cut three different pieces of patterned paper. I picked bright colors as I wanted to make this card as fun and possible as I could!!

I then used the smallest hexagon die from the Hexagons In-Betweens die set to randomly die cut four hexagons from the card layer. And then again used the small hexagon to die cut them from pattern paper.



I then placed the hexagon patterned pieces into the die cut areas on the main layer.  Four of them were adhered to the actual card base and the other three I used a pop-dot so they would be the same height as the layer. I finished the card off by adding some bright colored enamel dots!!!


*** Materials for this project available at www.franticstamper.com.
 
FRA-Die-09830
 
FRA-Die-09829

2 comments:

  1. Love the card! I'm newer to card making..... I wonder what type of glue you use to hold the enamel dots on.... I have been probably putting too much of the glue I'm using on the dots, but when it dries it is still tacky even though it is clear. Can you give some advice to a newbie? Thanks!!!

    ReplyDelete
  2. Ann, the enamel dots I use actually already have adhesive on them. My go to glue is the Scrap Happy Glue.

    ReplyDelete